Author Topic: Crap Heater  (Read 2576 times)

0 Members and 1 Guest are viewing this topic.

gedrick

  • Guest
  • Trade Count: (0)
Re: Crap Heater
« Reply #15 on: October 29, 2006, 10:18:27 AM »
I found that my heaters wernt working properly, gave the whole system a flush out, loads of sh*te stuck in there, also I think there was an air lock, sorted these out, and hey presto, nice load of heat coming out of the heaters
See what you're saying.
For the windscreen, prevention is better than cure. Last minute or so of every journey, turn heaters off and open windows - allows temps to equalise. Prevents this.

Aggree with this too, I do it and it helps loads.

Offline keef

  • Trade Count: (0)
  • Calibra Rookie
  • Posts: 140
  • Respect 0
  • Gender: Male
Re: Crap Heater
« Reply #16 on: October 29, 2006, 17:30:26 PM »
Also remember to change the pollen filter.

Its under the wiper cowling. When it gets clogged up and damp you don't get nearly as much 'blow' into the cabin.

I change mine when it starts getting hard to clear.

Also Clear the little meshes on each end of the cowling as these get blocked with leaves.

Hope that helps

nemesis

  • Guest
  • Trade Count: (0)
Re: Crap Heater
« Reply #17 on: November 14, 2006, 23:27:10 PM »
the main problems on calis is a blocked heater matrix two pipes under dis pack disconnect and bung a hose pipe down them flush the rust out til it runs clear or a blocked pollen filter no air gets through

carlos

  • Guest
  • Trade Count: (0)
Re: Crap Heater
« Reply #18 on: November 15, 2006, 11:47:15 AM »
Would apreciate some good step by step instructions on how to flush the matrix unit.