Official Vauxhall/Opel/Holden Calibra Technical Community

General => Calibra Chat, Discussion & Debate => Calibra Chat => Topic started by: Calibra55 on January 02, 2020, 12:45:58 PM

Title: Code reader for cablibra 1994
Post by: Calibra55 on January 02, 2020, 12:45:58 PM
Hi does anyone know where I can purchase a code reader for a calibration 1994
Title: Re: Code reader for cablibra 1994
Post by: agw9262 on January 02, 2020, 13:40:38 PM
You have a few options, from free to very expensive.

You can use a paperclip or short length jumper wire to trigger the built in diagnostics flash - engine management light flashes - then count the flashes. More here: http://www.clubcalibra.com/common-problems/guide-to-reading-ecu-codes/

Or you can buy opcom or similar from eBay or the likes - only works on the later models.

Finally you can buy the official GM reader but these tend to be very expensive.

Hope this helps.




Sent from my iPhone using Tapatalk
Title: Re: Code reader for cablibra 1994
Post by: Steva on January 12, 2020, 06:44:16 AM
I have tech 1 & tech 2 for my calibra they weren't cheap but they save me visiting garages


Steva
Title: Re: Code reader for cablibra 1994
Post by: agw9262 on January 12, 2020, 10:00:08 AM
Out of interest Steva, which one is used for which models of the Calibra?


Sent from my iPhone using Tapatalk
Title: Re: Code reader for cablibra 1994
Post by: Steva on January 16, 2020, 22:39:29 PM
Tech 1

C20NE
C20XE
C20LET
C20XEV
C25XE

Tech 2

X20XEV
X25XE

Steva